Installation |
|
|
|
|
|
|
|
|
|
|
| ||
| AUDIO |
| AUDIO |
| AUDIO |
| AUDIO |
| AUDIO |
| AUDIO |
| AUDIO |
IN | OUT | IN | OUT | IN | OUT | IN | OUT | IN | OUT | IN | OUT | IN | OUT |
|
| + |
| + | + |
| + |
| + |
| + |
| + |
|
| – |
| – | – |
| – |
| – |
| – |
| – |
7. RS BACK |
| 6. R SURR | 5. R FRONT | 4. CENTRE | 3. L FRONT |
| 2. L SURR | 1. LS BACK | |||||
|
| POWER INLET |
|
|
|
|
|
|
|
|
|
|
|
|
| 50 – 60 HZ |
|
|
|
|
|
|
|
|
|
|
|
|
| ~230V |
|
|
|
|
|
|
|
|
|
|
|
|
| 3700 VA MAX |
| 12V TRIGGER |
|
|
|
|
|
|
|
|
|
|
|
|
| IN |
|
|
|
|
|
|
|
|
|
POSITIONING THE UNIT
Place the amplifier on a level, firm surface.
Avoid placing the unit in direct sunlight or near sources of heat or damp.
Do not place the unit on top of a power amplifier or other sources of heat.
Ensure adequate ventilation.
The P7 has a variable speed fan for cooling. If the unit is placed in an enclosed space, such as a bookcase, equipment rack or cabinet, ensure that there is adequate space and ventilation in the enclosure for air to flow through the ventilation slots and cool the amplifier. Inadequate cabinet ventialtion may cause the P7 to shut down due to thermal overload.
The amplifier is designed to run warm during normal operation.
Ensure that the equipment rack or stand can support the 31kg weight of the unit.
CONNECTING TO A PRE-AMPLIFIER
ANALOGUE AUDIO INPUTS
It is imperative to connect the
All modules are identical. However, we advise you to make connections corresponding to rear panel labelling, since the amplifier modules are muted in pairs. Due to the layout of the power supply circuitry in the P7, you should connect the correct input signal and loudspeaker to the recommended channel, or the left/right stereo imaging will not be optimum.
The outputs from the
If you wish to use four modules to
12V TRIGGER INPUT
If your
Note that the trigger input is only active when the central power button on the front panel is depressed.
6
