Manuals / Ariens / Lawn and Garden / Snow Blower

Ariens 921023 quick start Step One Assemble Handlebars, Not attached

Models: 921023

1 30

Download 30 pages 55.33 Kb

Page 2

Step One: Assemble Handlebars

Step One: Assemble Handlebars

NOTE: The Ariens company has made changes to packaging that affects this serial number range.

If the upper handlebars on your unit came already attached please disregard the following six slides.

Not attached	Attached

Image 2

Ariens 921023 quick start Step One Assemble Handlebars, Not attached

Contents

Quick Start Guide Deluxe-Track 28 921023 s/n 75000 & upStep One Assemble Handlebars Not attachedStep One Assemble Handlebars Unfold Lower Handlebar NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebars Attach Upper Handlebar Assembly NOTE This slide applies to UNATTACHED handlebars ONLYNOTE Make sure the cable remains in the groove of the pulley Step One Assemble Handlebars Attach Control Cables1. Hook Spring end of attachment control cable to the clutch arm NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebars Unfold Upper Handlebar NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebars Connect Headlight Wire Harness NOTE This slide applies to UNATTACHED handlebars ONLYNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Install Trigger CableNOTE Trigger cable assembly comes attached to the Sno-thro unit Step One Assemble Handlebar NOTE This slide applies to ATTACHED handlebars ONLY1. Grease underside of discharge chute ring if not already greased Step Two Install Discharge Chute2. Remove mounting hardware from auger housing Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Control Cable Step Five Check Function of Dual Handle Interlock Step Six Check Track Tension Step Seven Adjust Skid Shoes see Check Auger Gearcase in Owners Manual Step Eight Check Auger Gearcase OilCheck oil level in auger gearcase in crankcase. Refer to Engine Manual for detailed instructions Step Nine Check Engine Crankcase OilIMPORTANT The engine is shipped with oil FILLING FUEL TANK in Step Ten Fill Engine Fuel TankFill fuel tank. DO NOT OVERFILL! See Owners ManualStep Eleven Starting the Engine Starting Engine / Step A Throttle Move the throttle control lever to the fast positionStarting Engine / Step B Fuel Valve Turn the fuel shut- off valve to the ON positionStarting Engine / Step C Key Insert the key and turn to the ON/START positionTurn the choke control knob to the choke position NOTE Choke is usually unnecessary when restarting a warm engineStarting Engine / Step D Choke Push the primer two times. Be sure to cover vent hole on primer bulb NOTE Priming is usually unnecessary when restarting a warm engineStarting Engine / Step E Prime or call Starting Engine / Step F Manual StartNOTE If the engine does not start after repeated attempts, go to BRIGGSandSTRATTON.COMStarting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Twelve Stopping the Engine Refer to Owners Manual and Engine Manual Contact Ariens Company For issues concerning engine, please contact Briggs and StrattonAdditional Resources E-mail info@ariens.com