Manuals / Ariens / Lawn and Garden / Snow Blower

Ariens 921023 quick start Step One Assemble Handlebars Unfold Lower Handlebar

Models: 921023

1 30

Download 30 pages 55.33 Kb

Page 3

Step One: Assemble Handlebars

Step One: Assemble Handlebars

(Unfold Lower Handlebar)

IMPORTANT: Be sure to block wheels or secure unit so it does not move during assembly.

1.Rotate lower handlebar out from unit so lower handlebar mounting holes align with mounting holes on the unit frame.

2.Secure lower handlebar to unit using two 3/8 in x 3/4 in. hex head serrated flange grade 5 bolts.

3.Tighten all four bolts to 25-42 lbf-ft (33,9-56,9 N∙m)

NOTE: This slide applies to

UNATTACHED handlebars ONLY

Image 3

Ariens 921023 Step One Assemble Handlebars Unfold Lower Handlebar, NOTE This slide applies to UNATTACHED handlebars ONLY

Contents

Deluxe-Track 28 921023 s/n 75000 & up Quick Start GuideNot attached Step One Assemble HandlebarsNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Unfold Lower HandlebarNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Attach Upper Handlebar AssemblyNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Attach Control Cables1. Hook Spring end of attachment control cable to the clutch arm NOTE Make sure the cable remains in the groove of the pulleyNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Unfold Upper HandlebarNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Connect Headlight Wire HarnessStep One Assemble Handlebars Install Trigger Cable NOTE Trigger cable assembly comes attached to the Sno-thro unitNOTE This slide applies to UNATTACHED handlebars ONLY NOTE This slide applies to ATTACHED handlebars ONLY Step One Assemble HandlebarStep Two Install Discharge Chute 2. Remove mounting hardware from auger housing1. Grease underside of discharge chute ring if not already greased Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Control Cable Step Five Check Function of Dual Handle Interlock Step Six Check Track Tension Step Seven Adjust Skid Shoes Step Eight Check Auger Gearcase Oil Check oil level in auger gearcasesee Check Auger Gearcase in Owners Manual Step Nine Check Engine Crankcase Oil IMPORTANT The engine is shipped with oilin crankcase. Refer to Engine Manual for detailed instructions Owners Manual Step Ten Fill Engine Fuel TankFill fuel tank. DO NOT OVERFILL! See FILLING FUEL TANK inStep Eleven Starting the Engine Move the throttle control lever to the fast position Starting Engine / Step A ThrottleTurn the fuel shut- off valve to the ON position Starting Engine / Step B Fuel ValveInsert the key and turn to the ON/START position Starting Engine / Step C KeyNOTE Choke is usually unnecessary when restarting a warm engine Starting Engine / Step D ChokeTurn the choke control knob to the choke position NOTE Priming is usually unnecessary when restarting a warm engine Starting Engine / Step E PrimePush the primer two times. Be sure to cover vent hole on primer bulb BRIGGSandSTRATTON.COM Starting Engine / Step F Manual StartNOTE If the engine does not start after repeated attempts, go to or callStarting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Twelve Stopping the Engine E-mail info@ariens.com For issues concerning engine, please contact Briggs and StrattonAdditional Resources Refer to Owners Manual and Engine Manual Contact Ariens Company