Manuals
/
Ariens
/
Lawn and Garden
/
Snow Blower
Ariens
921023 Starting Engine / Step D Choke, Turn the choke control knob to the choke position
Models:
921023
1
23
30
30
Download
30 pages
55.33 Kb
20
21
22
23
24
25
26
27
<
>
Install
Step One Assemble Handlebars Connect Headlight Wire Harness
For issues concerning engine, please contact Briggs and Stratton
Step One Assemble Handlebars Attach Upper Handlebar Assembly
Step Seven Adjust Skid Shoes
How to
Remove mounting hardware from auger housing
Page 23
Image 23
Starting Engine / Step D:
Choke
Turn the choke control knob to the choke position.
NOTE:
Choke is usually unnecessary when restarting a warm engine.
Page 22
Page 24
Page 23
Image 23
Page 22
Page 24
Contents
Deluxe-Track 28 921023 s/n 75000 & up
Quick Start Guide
Not attached
Step One Assemble Handlebars
NOTE This slide applies to UNATTACHED handlebars ONLY
Step One Assemble Handlebars Unfold Lower Handlebar
NOTE This slide applies to UNATTACHED handlebars ONLY
Step One Assemble Handlebars Attach Upper Handlebar Assembly
NOTE This slide applies to UNATTACHED handlebars ONLY
Step One Assemble Handlebars Attach Control Cables
1. Hook Spring end of attachment control cable to the clutch arm
NOTE Make sure the cable remains in the groove of the pulley
NOTE This slide applies to UNATTACHED handlebars ONLY
Step One Assemble Handlebars Unfold Upper Handlebar
NOTE This slide applies to UNATTACHED handlebars ONLY
Step One Assemble Handlebars Connect Headlight Wire Harness
NOTE This slide applies to UNATTACHED handlebars ONLY
Step One Assemble Handlebars Install Trigger Cable
NOTE Trigger cable assembly comes attached to the Sno-thro unit
NOTE This slide applies to ATTACHED handlebars ONLY
Step One Assemble Handlebar
1. Grease underside of discharge chute ring if not already greased
Step Two Install Discharge Chute
2. Remove mounting hardware from auger housing
Step Three Install Discharge Chute Crank
Step Four Install Remote Deflector Control Cable
Step Five Check Function of Dual Handle Interlock
Step Six Check Track Tension
Step Seven Adjust Skid Shoes
see Check Auger Gearcase in Owners Manual
Step Eight Check Auger Gearcase Oil
Check oil level in auger gearcase
in crankcase. Refer to Engine Manual for detailed instructions
Step Nine Check Engine Crankcase Oil
IMPORTANT The engine is shipped with oil
Owners Manual
Step Ten Fill Engine Fuel Tank
Fill fuel tank. DO NOT OVERFILL! See
FILLING FUEL TANK in
Step Eleven Starting the Engine
Move the throttle control lever to the fast position
Starting Engine / Step A Throttle
Turn the fuel shut- off valve to the ON position
Starting Engine / Step B Fuel Valve
Insert the key and turn to the ON/START position
Starting Engine / Step C Key
Turn the choke control knob to the choke position
NOTE Choke is usually unnecessary when restarting a warm engine
Starting Engine / Step D Choke
Push the primer two times. Be sure to cover vent hole on primer bulb
NOTE Priming is usually unnecessary when restarting a warm engine
Starting Engine / Step E Prime
BRIGGSandSTRATTON.COM
Starting Engine / Step F Manual Start
NOTE If the engine does not start after repeated attempts, go to
or call
Starting Engine / Step F Electric Start
Starting Engine / Step G Electric Start
Starting Engine / Step H Warm up
Step Twelve Stopping the Engine
E-mail info@ariens.com
For issues concerning engine, please contact Briggs and Stratton
Additional Resources
Refer to Owners Manual and Engine Manual Contact Ariens Company