Manuals / Ariens / Lawn and Garden / Snow Blower

Ariens 921023 quick start Step One Assemble Handlebars Attach Upper Handlebar Assembly

Models: 921023

1 30

Download 30 pages 55.33 Kb

Page 4

Step One: Assemble Handlebars

Step One: Assemble Handlebars

(Attach Upper Handlebar Assembly)

1.Attach upper handlebar assembly to lower handlebar using two sets of the handlebar hardware. One set to attach each side of the handlebars.

NOTE: DO NOT tighten hardware. Allow upper handlebar assembly to hang from the lower handlebars for the next step.

NOTE: This slide applies to

UNATTACHED handlebars ONLY

Image 4

Ariens 921023 quick start Step One Assemble Handlebars Attach Upper Handlebar Assembly

Contents

Quick Start Guide Deluxe-Track 28 921023 s/n 75000 & upStep One Assemble Handlebars Not attachedStep One Assemble Handlebars Unfold Lower Handlebar NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebars Attach Upper Handlebar Assembly NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebars Attach Control Cables 1. Hook Spring end of attachment control cable to the clutch armNOTE Make sure the cable remains in the groove of the pulley NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebars Unfold Upper Handlebar NOTE This slide applies to UNATTACHED handlebars ONLYStep One Assemble Handlebars Connect Headlight Wire Harness NOTE This slide applies to UNATTACHED handlebars ONLYNOTE Trigger cable assembly comes attached to the Sno-thro unit Step One Assemble Handlebars Install Trigger CableNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebar NOTE This slide applies to ATTACHED handlebars ONLY2. Remove mounting hardware from auger housing Step Two Install Discharge Chute1. Grease underside of discharge chute ring if not already greased Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Control Cable Step Five Check Function of Dual Handle Interlock Step Six Check Track Tension Step Seven Adjust Skid Shoes Check oil level in auger gearcase Step Eight Check Auger Gearcase Oilsee Check Auger Gearcase in Owners Manual IMPORTANT The engine is shipped with oil Step Nine Check Engine Crankcase Oilin crankcase. Refer to Engine Manual for detailed instructions Step Ten Fill Engine Fuel Tank Fill fuel tank. DO NOT OVERFILL! SeeFILLING FUEL TANK in Owners ManualStep Eleven Starting the Engine Starting Engine / Step A Throttle Move the throttle control lever to the fast positionStarting Engine / Step B Fuel Valve Turn the fuel shut- off valve to the ON positionStarting Engine / Step C Key Insert the key and turn to the ON/START positionStarting Engine / Step D Choke NOTE Choke is usually unnecessary when restarting a warm engineTurn the choke control knob to the choke position Starting Engine / Step E Prime NOTE Priming is usually unnecessary when restarting a warm enginePush the primer two times. Be sure to cover vent hole on primer bulb Starting Engine / Step F Manual Start NOTE If the engine does not start after repeated attempts, go toor call BRIGGSandSTRATTON.COMStarting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Twelve Stopping the Engine For issues concerning engine, please contact Briggs and Stratton Additional ResourcesRefer to Owners Manual and Engine Manual Contact Ariens Company E-mail info@ariens.com