Manuals / Ariens / Lawn and Garden / Snow Blower

Ariens 921023 Step One Assemble Handlebar, NOTE This slide applies to ATTACHED handlebars ONLY

Models: 921023

1 30

Download 30 pages 55.33 Kb

Page 9

Step One:

Step One:

Assemble Handlebar

1.Remove the lower and loosen the upper hardware on the handlebar assembly.

2.Loosen the hardware on the shift rod.

3.Put the speed selector lever in the sixth forward position.

4.Rotate the handlebar into operating position.

NOTE: Be careful not to damage cable spring hooks when rotating handlebar upward.

5.Install and tighten the hardware on the handlebar assembly and shift rod.

NOTE: This slide applies to ATTACHED handlebars ONLY

Image 9

Ariens 921023 quick start Step One Assemble Handlebar, NOTE This slide applies to ATTACHED handlebars ONLY

Contents

Deluxe-Track 28 921023 s/n 75000 & up Quick Start GuideNot attached Step One Assemble HandlebarsNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Unfold Lower HandlebarNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Attach Upper Handlebar Assembly1. Hook Spring end of attachment control cable to the clutch arm Step One Assemble Handlebars Attach Control CablesNOTE Make sure the cable remains in the groove of the pulley NOTE This slide applies to UNATTACHED handlebars ONLYNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Unfold Upper HandlebarNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Connect Headlight Wire HarnessStep One Assemble Handlebars Install Trigger Cable NOTE Trigger cable assembly comes attached to the Sno-thro unitNOTE This slide applies to UNATTACHED handlebars ONLY NOTE This slide applies to ATTACHED handlebars ONLY Step One Assemble HandlebarStep Two Install Discharge Chute 2. Remove mounting hardware from auger housing1. Grease underside of discharge chute ring if not already greased Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Control Cable Step Five Check Function of Dual Handle Interlock Step Six Check Track Tension Step Seven Adjust Skid Shoes Step Eight Check Auger Gearcase Oil Check oil level in auger gearcasesee Check Auger Gearcase in Owners Manual Step Nine Check Engine Crankcase Oil IMPORTANT The engine is shipped with oilin crankcase. Refer to Engine Manual for detailed instructions Fill fuel tank. DO NOT OVERFILL! See Step Ten Fill Engine Fuel TankFILLING FUEL TANK in Owners ManualStep Eleven Starting the Engine Move the throttle control lever to the fast position Starting Engine / Step A ThrottleTurn the fuel shut- off valve to the ON position Starting Engine / Step B Fuel ValveInsert the key and turn to the ON/START position Starting Engine / Step C KeyNOTE Choke is usually unnecessary when restarting a warm engine Starting Engine / Step D ChokeTurn the choke control knob to the choke position NOTE Priming is usually unnecessary when restarting a warm engine Starting Engine / Step E PrimePush the primer two times. Be sure to cover vent hole on primer bulb NOTE If the engine does not start after repeated attempts, go to Starting Engine / Step F Manual Startor call BRIGGSandSTRATTON.COMStarting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Twelve Stopping the Engine Additional Resources For issues concerning engine, please contact Briggs and StrattonRefer to Owners Manual and Engine Manual Contact Ariens Company E-mail info@ariens.com