•In case of internal contact, DO NOT induce vomiting!

Before tipping unit up onto housing, remove fuel so no spills will occur and remove battery. Ensure unit is secure and will not tip over during maintenance.

ALWAYS keep protective structures, guards, and panels in good repair, in place and securely fastened. NEVER modify or remove safety devices.

DO NOT change engine governor settings or over-speed engine.

Fumes from engine exhaust can cause injury or death. DO NOT run engine in an enclosed area. Always provide good ventilation.

ALWAYS maintain unit in safe operating condition. Damaged or worn out muffler can cause fire or explosion.

Keep all hardware properly tightened. Check shear bolts frequently.

Maintain or replace safety and instruction labels, as necessary.

NEVER store unit with fuel in fuel tank, inside a building where any ignition sources are present such as hot water heaters, space heaters, or clothes dryers. Allow the engine to cool before storing in any enclosure.

Shut off fuel and allow engine to cool completely before storing in closed area or covering unit.

For extended storage, clean unit thoroughly. See Engine Manual for proper storage.

Use only attachments or accessories designed for your unit.

Check components frequently. If worn or damaged, replace with manufacturer’s recommended parts.

ASSEMBLY

WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.

WARNING: Dropping or tipping over boxed unit could result in personal injury or damage to unit.

Tools Required:

•Pliers

•Open-End Wrenches: 3/8, 7/16, 1/2, 9/16" and/or Adjustable Wrench

•Tire Gauge

PACKAGE CONTENTS

1

2

3

4

1. Sno-Thro Unit

3. Discharge Chute

2. Chute Crank

4. Literature Pack

(Not on 924517)

with Extra Shear

 

Bolts

OS1642

Figure 3

ASSEMBLY

Handlebar and Shift Rod

1.Remove lower wing knobs on handlebar assembly (Figure 4).

2.Remove upper wing nut and bolt on shift rod.

3.Loosen upper wing knobs on handlebar.

4.Loosen lower wing nut and bolt on shift rod.

5.Put speed selector lever into fastest reverse panel notch.

6.Rotate handlebar up so wing knob holes align. Install and tighten all wing knobs.

7.Install wing nut and bolt removed in step 2 on shift rod and tighten hardware.

GB - 9