Differential Lock (924124, 126, 127, 335, 336, 337, 516, 517)

Differential Lock knob is located

1on the Left Wheel Hub. With

differential locked power is applied equally to both wheels.

To engage differential lock:

2• Pull and turn knob to LOCKED

(1) position and release (knob

will snap in place when positioned correctly).

OL2730 To resume differential action for transport:

•Pull and turn knob to UNLOCKED (2) position and release.

Axle Lock Pin (Figure 13) (924125, 128, 338)

Use the axle lock pin to lock or unlock the right wheel. Lock the right wheel to increase traction; unlock the right wheel to allow for easier turning of the unit.

Wheel Unlocked

Axle

Wheel Locked Lock

Pin

Figure 13

Scraper Blade

The scraper blade allows the back of the housing to keep better contact with the surface being cleared. It also prevents damage to the housing from normal wear.

IMPORTANT: DO NOT allow Scraper Blade to wear too far or Auger/Impeller housing will become damaged.

Runners

The runners control the distance between the scraper blade and the ground. Adjust runners equally to keep blade level with the ground.

Refer to Pre-Startfor recommended settings.

Drift Cutters (Figure 14)

Drift cutters break up snow drifts that are taller than the auger housing and direct the snow into the auger. Store the drift cutters on the auger housing when not in use. Install them as shown below so they are taller than the snow to be cleared.

1

2

1. Stored Position

2. Operating Position

Figure 14

GB - 16