1.Select Speed Control position and direction.

2.Engage Attachment Clutch - Right Hand Lever.

3.Engage Traction Drive Clutch - Left Hand Lever.

IMPORTANT: DO NOT overload unit capacity by attempting to clear snow at too fast a rate. Use slow speed to clear deep or hard packed snow.

Tips for Operation

Snow is best removed as soon as possible after snow fall.

To clear an area, run unit in an overlapping series of paths. For large areas; start in the middle and throw snow to each side, so snow is not cleared more than once.

ALWAYS direct snow away from area to be cleared and with direction of the wind.

TRAVELING

To travel from one work area to another:

1.Set Throttle to Slow or Part-Throttle position.

2.Press down on handlebars enough to raise front of unit slightly off surface.

3.Engage wheel drive clutch without engaging attachment drive clutch.

TRANSPORT

ALWAYS shut off engine, remove key, and close fuel shut-off valve when transporting unit on a truck or trailer.

Use extra care when loading or unloading unit onto trailer or truck.

Secure unit chassis to transport vehicle. NEVER secure from rods or linkages that could be damaged.

DO NOT transport machine while engine is running.

MAINTENANCE

Ariens Dealers will provide any service or adjustments which may be required to keep your unit operating at peak efficiency. Should engine service be required, contact an Ariens dealer or an authorized engine manufacturer's service center.

WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.

SERVICE POSITION

WARNING: Before tipping unit up onto housing, remove fuel so no spills will occur and remove battery (if equipped). Ensure unit is secure and will not tip over during maintenance.

Place unit on a flat level surface. Tip unit forward onto front of impeller housing for service. Ensure unit is secure and will not tip over. Strap and clamp onto bench if needed.

MAINTENANCE SCHEDULE

The chart below shows the recommended maintenance schedule that should be performed on a regular basis. More frequent service may be required.

MAINTENANCE

SCHEDULE

Service

Each

Every

Every

Yearly

Performed

Use

5 hrs.

25

 

 

 

 

hrs.

 

 

 

 

 

 

Check Dual

•

 

 

 

Handle

 

 

 

 

Interlock

 

 

 

 

 

 

 

 

 

Check

•

 

 

 

Fasteners

 

 

 

 

 

 

 

 

 

Check

•

 

 

 

Clutches

 

 

 

 

 

 

 

 

 

Clean Engine

•

 

 

 

 

 

 

 

 

Check Engine

 

•

 

 

Oil

 

 

 

 

 

 

 

 

 

Change

 

*

•

 

Engine Oil

 

 

 

 

 

 

 

 

 

 

 

 

Check Tire

 

 

•

 

Pressure

 

 

 

 

 

 

 

 

 

Check Auger

 

 

•

•

Gearcase

 

 

 

 

 

 

 

 

 

General

 

 

•

•

Lubrication

 

 

 

 

 

 

 

 

 

Battery

 

 

•

•

Maintenance

 

 

 

 

 

 

 

 

 

*After first two hours of operation.

GB - 19