1.Remove chute motor cover from chute motor (Figure 7).
2.Turn the chute gear until the solid pin is towards the rear of the unit and a threaded stud aligns with the chute motor (Figure 7).
3.Remove the six (6) nuts and two half rings (Figure 7).
4.Make sure the three (3) chute clamps on the chute gear are underneath the discharge chute flange as shown in (Figure 8)
5.Install discharge chute on blower housing with the opening of the discharge chute facing towards the front of the unit (Figure 9).
6.Install two (2) half rings on unit with six (6) nuts. Tighten nuts to 120
(13.56 N•m) (Figure 9).
7.Install chute motor cover on chute motor (Figure 9).
1 2 3
7 | 6 | 5 | 4 |
| |||
1. Solid Pin |
| 5. Chute Ring | |
2. Threaded Stud | 6. Nut | ||
3. Chute Motor |
| 7. Half Ring | |
4.Chute Motor Cover
Figure 7
Correct Chute Clamp Orientation
Incorrect Chute Clamp Orientation
1
5 | 2 | 4 |
3 | ||
1. Chute Clamp | 3. Discharge Chute | |
2. Chute Gear | Flange |
|
Figure 8 |
| |
1 | 4 | |
2 | ||
3 | ||
1. Discharge Chute | 3. Nut | |
2. Half Ring | 4. Chute Motor | |
| Cover |
Figure 9
GB - 11