2

8

6

5

4

1 1 1 1 7

3

1. Auger and Shaft

5. Shift Lever Arm

 

2. Discharge Chute

6. Pinion Chain

 

3. Sprocket/Pinion

7. Hex Shaft

Grease Oil

Assembly

8. Shift Link

 

4. Axle Shaft

 

 

OS0642

OS0741

Figure 15

CLEAN BATTERY (924516, 517)

WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.

IMPORTANT: Battery is maintenance-free. Do not tamper with or attempt to open battery. See Service and Adjustments for charging procedures.

Terminals

Keep battery and its terminals clean.

IMPORTANT: Remove battery from unit before cleaning.

Remove corrosion from battery terminals and cable connections with a wire brush, then wash with a weak baking soda solution.

After cleaning, apply a thin coat of grease or petroleum jelly to terminals and cable ends to retard corrosion.

SERVICE AND ADJUSTMENTS

WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.

DEFLECTOR REMOTE

Deflector must stay in selected position while throwing snow.

If deflector does not stay in set position:

1.Tighten nut beneath the control panel to increase friction on pressure flange (Figure 16).

If deflector does not follow full range of travel:

1.Push deflector remote all the way forward.

2.Loosen adjusting nuts on cable support bracket.

3.To adjust the deflector lower:

Slide cable down. Tighten bottom nut.

4.To adjust deflector higher: Slide cable up. Tighten top nut.

5.Check travel and repeat adjustment as necessary.

GB - 21