Installation
NA
Floor Standpipe Drain
Sink Drainpipe Method
(A) |
|
62 - 86 cm |
Top of standpipe must be at least 25 inches (62 cm) high and no higher than 34 inches (86 cm) from the bottom of the washer (A).
Entry into the sink drain system must be above the trap (see fig. aside ).
When routing the drain hose through cabinets or
walls use aprotective
material such as
electrical duct tape to
cover sharp edges that
could damage the drain
hose. Use a suitable clamp to secure the drain hose to the “Y” branch or
the disposer. With a sink drainpipe system (see figures aside and below), you may connect directly:
25”
34”
Wall Standpipe Drain
Top of standpipe must be at least 25 inches (62 cm) min.; 34 inches (86 cm) max from end of drain hose to bottom of washer (B) (See figures aside and below).
#^
1)to a disposer by following the manufacturers attachement method.
2)directly to a “Y” branch tail piece (Available at most hardware stores).
3)through the floor to a separate trap. The trap must be vented to prevent siphoning. To provide proper venting , install an Air Gap Kit (available at most hardware stores).
4)To the faucet using a Faucet Adapter Kit (available separately). It will supply water from your faucet and discharge water directly into your sink drain.
Under Sink Method
1. Cut the blocked end of the under sink drainage unit.
| 2. Fix the hooked end | |
| ||
| supporta minimum of | |
| 620 mm from the floor. | |
H o s e | 3. Use a hose clip clamp | |
to securely attach the | ||
clamp | ||
| grey drainage hose | |
620 mm | end to the under sink | |
| drainage unit using a | |
| hose. clamp | |
|
8 | www.aristonappliances.us |
|
