SETTING

 

SETTING MENU

1

Press the MENU button and the ON-SCREEN MENU will

appear. Press the POINT LEFT/RIGHT buttons to select

 

SETTING and press the SELECT button. Another dialog box

 

SETTING Menu will appear.

2

Press the POINT DOWN button and a red-arrow icon will

appear. Move the arrow to the item that you want to set, and

then press the SELECT button to set it "On" or "Off" or press the POINT LEFT/RIGHT button to adjust the value.

Blue back

When this function is “On,” this projector will produce a blue image instead of the video noise on the screen when the input source is unplugged or turned off.

Display

This function decides whether to display the On-Screen Displays.

On1 ···shows all the On-Screen Displays.

On2 ···shows the On-Screen Displays except the Preparation Display (Our Logo).

Off ····sets the On-Screen Displays disappeared except;

●ON SCREEN MENU

●“Power off?” message

●P-TIMER

Power management

This function turns the Projection Lamp off when the projector detects signal interruption and the projector is not used for a certain period in order to reduce power consumption and maintain the Lamp- life. (This projector is shipped with this function ON.)

Power Management function operates to turn the Projection Lamp off when the input signal is interrupted and the projector is not operated over 5 minutes. This function operates as follows;

1.When the signal is interrupted, “No signal” and the counting down (5 minutes) display appears.

2.When the Projection Lamp turned off, the READY indicator turns off. The Cooling Fans operate for 90 seconds after the Projection Lamp is turned off. (During this "Cooling Down" period, the Lamp cannot be turned on.)

3.When the Lamp has cooled down, the READY indicator flashes and the Lamp can be turned on again (Power Management mode).

In this Power Management mode, the Projection Lamp is automatically turned on when the input signal connected or the projector is operated with any button on the Top Control or the Remote Control.

On start

When this function is “On,” the projector is automatically turned on just by switching the MAIN ON / OFF SWITCH on.

Note ; Be sure to turn the projector off properly (refer to the section “TURNING OFF THE PROJECTOR” on page 20.). If the projector is turned off in the wrong steps, the On Start function does not operate properly.

Set the Pointer to the item and press the SELECT button.

Time left until Lamp off.

36