SETTING

Ceiling

When this function is “On,” the top / bottom and the left / right reversed picture is provided to project the image from a ceiling mounted projector.

Rear

When this function is “On,” the left / right reversed picture is provided to project the image to a rear projection screen.

Split wipe

Turn this function “On” in the SETTING menu. The picture will change into next one by sliding black image side ways like drawing the black curtains when the input source is turned into another one.

Remote control

This projector has two different remote transmit codes; the factory- set normal code (Mode 1) and the secondary code (Mode 2). This switching function prevents the remote control operation mixture (jam) when operating several projectors or video equipment together. When operating the projector in “Mode 2,” both projector and Remote Control must be switched to “Mode 2.”

To change the code of the projector;

Set the Remote control in the SETTING menu to “Mode 2.”

To change the code of the Remote Control;

Press both the MENU and the NORMAL buttons on the Remote Control together for over 10 seconds.

After changing the code, make sure the Remote Control operates properly.

To return to the normal code (Mode 1), operate both projector and Remote Control in the ways above again.

NOTE : When the ALL-OFF switch on the Remote Control Unit is turned to “ALL-OFF,” the remote transmit code automatically returns to the normal code (Mode 1).

Lamp age

The Lamp age function is designed to reset the lamp replacement monitor timer. When replacing the lamp, reset the lamp replacement monitor timer by using this function. (Refer to page 40.)

Ceiling function

Rear function

SELECTING LANGUAGE

The language used in the ON-SCREEN MENU is selectable from among English, German, French, Italian, Spanish and Japanese.

1

Press the MENU button and the ON-SCREEN MENU will

appear.

Press POINT LEFT/RIGHT buttons to select

 

LANGUAGE and press the SELECT button. Another dialog box

 

LANGUAGE Menu will appear.

2

Press the POINT DOWN button and a red-arrow icon will

appear.

Move the arrow to the language that you want to set,

and then press the SELECT button.

Move the Pointer to the language that you want to set, and then press the SELECT button.

37