Advanced
The Advanced screen contains parameters involving your hardware devices. It also provides advanced settings of the system.
FIR Ports
Configure the system’s infrared port using options: Disabled and Enabled.
Insyde Software SCU
Main Advanced
Infrared Ports(FIR)
Parallel Port(LPT)
Legacy USB support
| May 20, 2003 5:40:09 | |||
Security | Boot |
| Exit | |
| ||||
| ||||
( | ) Disabled |
| ( | ) Normal (16550) |
( | ) COM1,3F8,IRQ4 |
| ( | ) IrDA (HPSIR) |
( | ) COM2,2F8,IRQ3 |
| ( | ) ASK IR |
( | ) COM3,3E8,IRQ4 |
| ( | ) FAST IR |
( | ) COM4,2E8,IRQ3 |
|
|
|
( | ) DMA1 |
( | ) DMA2 |
( | ) DMA3 |
OKCancel
<Tab> <Right> <Left> for block select. <Up> <Down> for item select.
<Enter> for accept. <Cancel> <Esc> for reject. <Alt> activates accelerators. <Space> for Enable or Disable.
The table below describes the parameters in the screen. Settings in boldface are the default and suggested parameter settings.
| Description | Option |
|
|
|
FIR I/O Settings | Sets the base I/O address and IRQ for | COM1, 3F8, IRQ4/ COM2, |
| Infrared port. | 2F8, IRQ3/ COM3, 3E8, |
|
| IRQ4/ COM4, 2E8, IRQ3 |
DMA Setting for Fast | Sets a DMA channel for the printer to | DMA1, DMA2, DMA3, |
IR | operate in ECP mode. This parameter is |
|
| enabled only if Mode is set to ECP. |
|
|
|
|
Mode Setting |
| Normak (16550), IrDA |
|
| (HPSIR), ASK IR, FAST IR |
Chapter 2 | 48 |
