Because Intel® ICH7R south bridge only supports four IDE devices under legacy OS (Windows NT), you have to choose [SATA0, 1, 2, 3], [IDE1, SATA1, SATA3], and [SATA0, SATA2, IDE1] when the installed device is used with legacy OS.
|
|
| [SATA0, 1, 2, 3] | [SATA0, SATA2, IDE1] | [IDE1, SATA1, SATA3] | ||
|
|
|
|
|
| ||
|
|
| SATAII_BLUE | SATAII_BLUE | SATAII_BLACK | ||
| Master |
| (PORT0), | (PORT0) | (PORT1) | ||
|
|
| SATAII_BLACK |
|
|
| |
|
|
| (PORT1) |
|
|
| |
|
|
|
|
|
| ||
| Slave |
| SATAII_RED | SATAII_RED | SATAII_ORANGE | ||
|
| (PORT2), | (PORT2) | (PORT3) | |||
|
|
| |||||
|
|
| SATAII_ORANGE |
|
|
| |
|
|
| (PORT3) |
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| BIOS SETUP UTILITY |
|
| |
|
| Advanced |
|
|
|
| |
Primary IDE Master
Device | :Hard Disk |
Vendor | :ST340014A |
Size | :40.0 GB |
LBA Mode | :Supported |
Block Mode | :16Sectors |
PIO Mode | :4 |
Async DMA | :MultiWord |
Ultra DMA | :Ultra |
S.M.A.R.T. | :Supported |
|
|
Type | [Auto] |
LBA/Large Mode | [Auto] |
Block | [Auto] |
PIO Mode | [Auto] |
DMA Mode | [Auto] |
S . M . A . R . T . | [Disabled] |
32Bit Data Transfer | [Enabled] |
Select the type
of device connected to the system.
| Select Screen |
| Select Item |
+- | Change Option |
F1 | General Help |
F9 | Load Defaults |
F10 | Save and Exit |
ESC | Exit |
v02.54 (C) Copyright
TYPE
Use this item to configure the type of the IDE device that you specify. Configuration options: [Not Installed], [Auto], [CD/DVD], and [ARMD].
[Not Installed]: Select [Not Installed] to disable the use of IDE device.
[Auto]: Select [Auto] to automatically detect the hard disk drive.
After selecting the hard disk information into BIOS, use a disk utility, such as FDISK, to partition and format the new IDE hard disk drives. This is necessary so that you can write or read data from the hard disk. Make sure to set the partition of the Primary IDE hard disk drives to active.
[CD/DVD]: This is used for IDE CD/DVD drives.
[ARMD]: This is used for IDE ARMD (ATAPI Removable Media Device), such as MO.
5 1
