ASRock P67 Pro3 manual Onboard Headers and Connectors

2.6 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard!

FDD connector

(33-pin FLOPPY1)

(see p.2 No. 29)

the red-striped side to Pin1

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector.

Serial ATAII Connectors				These four Serial ATAII (SATAII)
(SATA2_2: see p.2, No. 18)		SATA2_3	SATA2_2	connectors support SATA data
(SATA2_3: see	p.2, No. 17)			cables for internal storage
(SATA2_4: see	p.2, No. 19)			devices. The current SATAII
(SATA2_5: see p.2, No. 20)		SATA2_5	SATA2_4	interface allows up to 3.0 Gb/s
				data transfer rate.
Serial ATA3 Connectors				These two Serial ATA3 (SATA3)
(SATA3_0: see	p.2, No. 16)			connectors support SATA data
(SATA3_1: see	p.2, No. 15)	SATA3_1	SATA3_0	cables for internal storage
				devices. The current SATA3
				interface allows up to 6.0 Gb/s
				data transfer rate. If you install
				the HDD on the eSATA port on
				the rear I/O, the internal
				SATA3_1 will not function.
Serial ATA (SATA)				Either end of the SATA data
Data Cable				cable can be connected to the
(Optional)				SATA / SATAII / SATA3 hard
				disk or the SATAII / SATA3
				connector on this motherboard.

19

English

ASRock P67 Pro3 Motherboard