Asus SABERTOOTH 990FX/GEN3 R2, 990FX R20, 990FXGEN3 Creating a RAID driver disk in Windows

5.2Creating a RAID driver disk

A floppy disk with the RAID driver is required when installing a Windows® operating system on a hard disk drive that is included in a RAID set.

• The motherboard does not provide a floppy drive connector. You have to use a USB floppy disk drive when creating a SATA RAID driver disk.

•Windows® XP may not recognize the USB floppy disk drive due to Windows® XP limitation. To work around this OS limitation, refer to section 5.2.4 Using a USB floppy disk drive.

5.2.1Creating a RAID driver disk without entering the OS

To create a RAID driver disk without entering the OS:

1.Boot your computer.

2.Press <Del> during POST to enter the BIOS setup utility.

3.Set the optical drive as the primary boot device.

4.Insert the support DVD into the optical drive.

5.Save changes and exit BIOS.

6.When the Make Disk menu appears, press <1> to create a RAID driver disk.

7.Insert a formatted floppy disk into the USB floppy disk drive, then press <Enter>.

8.Follow the succeeding screen instructions to complete the process.

5.2.2Creating a RAID driver disk in Windows®

To create a RAID driver disk in Windows®:

1.Start Windows®.

2.Plug the USB floppy disk drive and insert a floppy disk.

3.Place the motherboard support DVD into the optical drive.

4.Go to the Make Disk menu, and then click Intel AHCI/RAID Driver Disk to create a RAID driver disk.

5.Select USB floppy disk drive as the destination disk.

6.Follow the succeeding screen instructions to complete the process.

Write-protect the floppy disk to avoid a computer virus infection.

Chapter 5

ASUS SABERTOOTH 990FX/GEN3 R2.0 5-7