10. Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component

is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

A8N-SLI SE

+5VSB MB

Chassis Signal GND

CHASSIS

(Default)

A8N-SLI SE Chassis Intrusion Connector

11. Front panel audio connector (10-1 pin FP _AUDIO)

This connector is for a chassis-mounted front panel audio I/O module that supports legacy AC ʻ97 audio standard. Connect one end of the front panel audio I/O module cable to this connector.

A8N-SLI SE

FP_AUDIO

BLINE_OUT_L Line out_L

NC

BLINE_OUT_R Line out_R

+5VA MICPWR

AGND MIC2

A8N-SLI SE Front Panel Audio Connector

ASUS A8N-SLI SE

2-27

Page 51
Image 51
Asus manual Chassis intrusion connector 4-1 pin Chassis, A8N-SLI SE Front Panel Audio Connector