.3 H/WConnectors SETUP

3.HARDWARE SETUP

4)Wake-On-LAN Connector (3-pin WOL_CON)

This connector connects to a LAN card with a Wake-On-LAN output, such as the ASUS PCI-L101 Ethernet card (see 7. Appendix). The connector powers up the system when a wakeup packet or signal is received through the LAN card.

IMPORTANT: To use this feature, enable the Wake-On-LAN feature in BIOS (see 4.5.1 Power Up Control) and make sure that system has an ATX power supply with at least 720mA +5V standby power.

IMPORTANT: Requires an ATX power supply with at least 720mA +5 volt standby power.

WOL_CON

+5 Volt Standby PME

CUVL-VM

Ground

CUVL-VM Wake-On-LAN Connector

5)Wake-On-Ring Connector (2-pin WOR)

This connector connects to internal modem cards with a Wake-On-Ring output. The connector powers up the system when a ringup packet or signal is received through the internal modem card. NOTE: For external modems, Wake-On-Ring is detected through the COM port.

IMPORTANT: This feature requires that the Power Up On External Modem Act parameter is enabled (see 4.5.1 Power Up Control) and that the system has an ATX power supply with at least 720mA +5V standby power.

CUVL-VM

WOR

RI# Ground

2 1

CUVL-VM Wake-On-Ring Connector

30

ASUS CUVL-VM User’s Manual