Asus manual Chassis intrusion connector 4-1 pin CHASSIS1, P5GD2 Deluxe Chassis alarm lead

12 . Chassis intrusion connector (4-1 pin CHASSIS1)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pins labeled ÒChassis SignalÓ and ÒGroundÓ are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

P5GD2

CHASSIS1

+5VSB MB Chassis Signal GND

(Default)

P5GD2 Deluxe Chassis alarm lead

13 . Front panel audio connector (10-1 pin AAFP)

This connector is for a chassis-mounted front panel audio I/O module that supports either HD Audio or legacy AC Ô97 audio standard. Connect one end of the front panel audio I/O module cable to this connector.

P5GD2

AAFP

Azalia-compliant		AC’97-compliant
pin definition		pin definition
SENSE2_RETUR	PORT2 L	MIC2	AGND
	SENSE_SEND	MICPWR	+5VA
SENSE1_RETUR	PORT2 R	Line out_R	BLINE_OUT_R
PRESENCE#	PORT1 R	NC
GND	PORT1 L	Line out_L	BLINE_OUT_L

P5GD2 Deluxe Front panel connector

¥Use a chassis that provides a high-definition audio front panel audio

I/O to use the high-definition audio features.

¥The default setting of this connector is legacy ACÕ97 audio, if you want to use the High-Definition (Azalia) audio features, set the Front Panel Support Type in the BIOS to Azalia. See page 4-26.

2 - 32 Chapter 2: Hardware information