2.7.2 Internal
connectors
1. Floppy
disk drive connector 
This connector is for the provided Floppy Disk Drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection when using a FDD cable with a covered Pin 5.
1394P5L 
FLOPPY
PIN 1
NOTE: Orient the red markings on the floppy ribbon cable to PIN 1.
P5L 1394 Floppy Disk Drive Connector
2. IDE
connector 
_IDE)
This connector is for an Ultra DMA 100/66 signal cable. If you install two hard disk drives, you must configure the second drive as a slave device by setting its jumper accordingly. Refer to the hard disk documentation for the jumper settings.
•Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable.
•Use the
|
|
|
|
|
| P5L 1394 |
|
|
|
|
|
| PRI_IDE | ||||
|
|
|
|
|
|
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
PIN1
NOTE: Orient the red markings (usually zigzag) on the ID ribbon cable to PIN 1.
P5L 1394 IDE Connector |
Chapter 2: Hardware information |
