Asus P5W DH P5W DH DELUXE Fan connectors, P5W DH DELUXE Chassis intrusion connector, 12.Chassis intrusion connector (4-1pin CHASSIS)

12.Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

P5W DH DELUXE	MB	Signal
	+5VSB_	Chassis GND

CHASSIS (Default)

P5W DH DELUXE Chassis intrusion connector

13.CPU, Chassis, and Power Fan connectors (4-pin CPU_FAN, 3-pin PWR_FAN1, 3-pin PWR_FAN2, 3-pin CHA_FAN1, 3-pin CHA_FAN2)

The fan connectors support cooling fans of 2A (24W max.) at +12V. Connect the fan cables to the fan connectors on the motherboard, making sure that the black wire of each cable matches the ground pin of the connector.

P5W DH DELUXE

CPU_FAN

CPU_FAN

		GND CPU CPU CPU
		FAN FAN FAN
		IN
PWR_FAN1		PWM	PWR
PWR_FAN2
	PWR_FAN2 PWR_FAN1				For the rear
CHA_FAN1	Rotation			GND	chassis
CHA_FAN2	+12V			+12V
	GND			Rotation
	CHA_FAN1		CHA_FAN2

P5W DH DELUXE Fan connectors

GND +12V Rotation GND +12V Rotation

For the side	For the front
chassis	chassis

2-38 Chapter 2: Hardware information