The PRI_IDE connector is for the Ultra ATA100 IDE hard disk ribbon cable. Connect the cable’s blue connector to the IDE connector, then connect the gray connector to a secondary master device (optical drive) and the black connector to the Ultra ATA100 primary master device (hard disk drive). Configure the hard disk drive and the optical drive as primary/secondary master device by adjusting their jumper settings. Refer to their respective documentation for details.
Pin 20 on the IDE connector is removed to match the covered hole on the Ultra ATA cable connector. This prevents incorrect orientation when you connect the cables.
For Ultra ATA133 IDE devices, use an
®P4R8T
P4R8T IDE Connectors
NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.
SEC IDE |
|
|
|
|
|
| PRI IDE |
|
|
|
|
|
| ||
|
|
|
|
| |||
|
|
|
|
| |||
|
| PIN 1 | |||||
These connectors allow you to receive stereo audio input from sound sources such as a
Left Audio Channel
Ground
Right Audio Channel
AUX(White)
®P4R8T
P4R8T Internal Audio Connectors
Left Audio Channel |
|
| Ground | Right Audio Channel | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
CD(Black)
76 | Chapter 4: Motherboard info |