AT&T 0II722050-917

Terminal Block

Connector

Table 2-1. AT&T PagePal J1 Modular Telephone Jack

Number Description

Not Used.

2C1 control input for Dry Loop (Page Port) activation by

closure (may also be used for Ground Start grounding

point).

3Ring (– polarity is important for Ground Start).

4Tip (+ polarity is important for Ground Start).

5C control input for Dry Loop (Page Port) activation by

contact closure.

Not Used.

This is a 20 Pin lug less-type terminal block located at J2 (see

Figure 2-1). See Table 2-2 for a contact descriptions.

Factory Test Connector J3 - No user connections

Wall Plug Transformer -115 VAC, 60 Hz. — U.L. Listed.

Installation 2-7

Contents

Main ii Contents Page Descrption LEVEL CONTROLS PagePal Figure 1-1. Front View of the AT&T PagePal Features Page Page Important Safety Instructions WARNING: General Information of Recorder Logging Balanced to Unbalanced Connections Modular Telephone Jack PAGEPAL Figure 2-1. Typical Connections to the AT&T PagePal Connectors (Rear Panel View) 2-6 Installation Page Table 2-2. AT&T PagePal J2 Terminal Block Connector Terminal Description 2-8 Installation Wall Mount Instructions Figure 2-2. Wall Mounting Adjustments Slide Switch Level Controls Attendant Input Music Input Troubleshooting Use Table 2-3 to assist in locating possible problems. 2-12 Installation Table 2-3. AT&T PagePal Troubleshooting Suggestions Installation 2-13 Table 2-3. PagePal Troubleshooting Suggestions (continued) 2-14 Installation Installation 2-15 2-16 Installation Appendix AFCC Regulations and Warranty FCC RegulationsPart 15 Radio Frequency Interference FCC RegulationsPart 68 Page Warranty Information Limited Warranty and Limitation of Liability Page Appendix BAT&T PagePal Functional Diagram PAGING EQUIPMENT INTERFACE Figure B-1. AT&T PagePal Functional Diagram Appendix CSecondary Circuit Protection Important Information Safety Information Installation Steps Figure C-2. PageGuard Installation Secondary Circuit Protection C-3