Recorder Logging
A tape recording may be desirable for evidence to prove
that certain announcements or warnings were made over
the paging system. The normally open contacts
(terminals 16 & 17, see Figure 2-1) may be used to
activate a tape recorder to record all tones and
announcements that were made, without the background
music in between which would consume large amounts
of tape.
Balanced to Unbalanced
The balanced inputs of the AT&T PagePal may be
driven by an unbalanced source. Simply connect the two
wires to the + and – input terminals.
Unbalanced inputs to power amplifiers may be driven
from the PagePal’s balanced output by connecting the
PagePal ground (terminal 14, see Figure 2-1) to the
input ground of the power amp, and the + or – output
(terminal 13 and 15, see Figure 2-1) of PagePal to the
“hot” input pin of the power amp. However, the output
level will be 6dB less.
Connections

Modular Telephone

Jack

The PagePal provides four connectors on the unit’s back panel
(see Figure 2-1). The following information describes each of
the connectors and their function.
This is a standard 6-pin telephone Modular type connector,
located at J1 on the unit back panel. See Table 2-1 for a
description of each of the pins.
Installation 2-5