1412 2002.12.7 9:20 AM Page 5

If you have two separate jacks, use both long line cords. Connect a line cord from the wall jack you wish to designate as your Line 1 to the jack labeled L1/L1+L2 on the back of the base. Connect the other line cord from the remaining wall jack to the jack labeled L2 on the back of the base. Make sure the plugs snap firmly into place.

Standard electrical outlet

Power

Cord

Line 2 Modular telephone jack

L1/L1+L2 Jack

L2 Jack

Line 1

Modular

telephone

jack

3Charge the handset battery.

Place the handset in the base. Charge the battery overnight the first time. After the first charge,the battery typically charges in eight hours.

4Check for dial tone.

After the batteries are charged,pick up the handset,press

and listen for a dial tone. Then press . If you don’t hear a dial tone,see IN CASE OF DIFFICULTY starting on page 52.

5Turn base ringers on or off.

Use the L1 RINGER and L2 RINGER switches on the right side of the base to set the base ringer volume to OFF, LOW or HIGH for each line.

5

Page 8
Image 8
AT&T 1412 user manual Charge the handset battery, Check for dial tone, Turn base ringers on or off