Feature setup
FEATURE | SYSTEM | OPTIONS | |
| ANNOUNCE |
| |
ANNOUNCEMENT | “Announcement | • Choose ON to listen to the announcement | |
MONITOR |
| monitor is…” | when the system answers a call. Choose OFF |
|
|
| to silence your end of the call. (The callers will |
|
|
| still hear the announcement.) |
|
|
| NOTE: Volume must be set to an audible level |
|
|
| to use the announcement monitor. |
|
|
|
|
NUMBER |
| “Number | • When this feature is on, the system will |
ANNOUNCE |
| announce is…” | announce the incoming telephone number |
(Please see |
|
| between the second and third rings. |
NOTE below) |
|
|
|
|
|
| NOTE: When the number announce feature is |
|
|
| on and ring select is set for two rings, the unit |
|
|
| will answer after three rings to allow enough |
|
|
| time for the system to announce the caller’s |
|
|
| telephone number. |
|
|
|
|
STORE NUMBER |
| “Store number is…” | • When this feature is on, the system announces |
(Please see |
|
| the incoming telephone number when it plays |
NOTE below) |
|
| back a message. |
|
|
|
|
ACCEPT BLOCK |
| “Accept block | • Choose ON to have the system accept all |
CALLS |
| calls is…” | calls. Choose OFF to have the system respond |
(Please see |
|
| to blocked calls with the |
NOTE below) |
|
| announcement, “We’re sorry, blocked calls to |
|
|
| this number cannot be accepted,” and hang up |
|
|
| without recording a message. |
|
|
| |
AUDIBLE MESSAGE | “Message alert is…” | • When this feature is on, the system beeps | |
ALERT |
|
| every 15 seconds when there are new |
|
|
| messages. |
NOTE: For this feature to work, you must subscribe to the caller ID service from your local telephone company. There may be a fee for this service, and it may not be available in all areas.
