AT&T 1739 user manual Memory is full, Delete messages, Message window displays Display FUnction

Operation

Memory is full

When the memory is full, or when 99 messages have been recorded, F flashes in the message window. You will then need to delete messages to make room for new ones. When the memory is full, the system will answer calls after 10 rings and will beep twice without playing the outgoing announcement. Enter your remote access code and delete some or all messages.

Delete messages

Delete messages — Press and hold DELETE. The system announces “Messages deleted” and permanently deletes all messages. The message window displays 0. If there are unreviewed messages, the system will play an error tone and will not delete any messages.

Delete selected messages — Press DELETE while the desired message is being played. The system will delete the message and play the next message. If you want to replay a message before deleting it, press MEMO/REPEAT. When the system reaches the end of the

last message, the messages not deleted are renumbered and the message window will then display the total number of messages remaining in memory.

Message window displays

DISPLAY FUnction

C	Clock needs to be reset or the system is in clock
	setting mode.
	Flashing — System is recording an announcement
	or a memo.
	Steady — Announcement playing
	—Or—
	system is recording a message
	—Or—
	remote access is in progress.
0	Rotating — Deleting.
F	Flashing — Memory is full.
8	Toll saver is set to 2/4.
9	Toll saver is set to 4/6.
	Feature is on.
	Feature is off.
E	Language is set to English.
F	Language is set to French.
0-7	Volume level appears when volume is adjusted.
0-98	Number of messages

(when system is idle).