AT&T 200 manual Initialization Error Messages

INITIALIZATION ERROR MESSAGES

Once you have completed all the connections successfully, the indicator lights on the upper right-hand corner of the AT&T VoiceMail Manager 200 should flash once, and the display will show INITIALIZING – PLEASE WAIT. The AT&T VoiceMail Manager 200 will run through a brief initialization process and then display NO CALLS.

During initialization, the AT&T VoiceMail Manager 200 may display one of several error messages:

☎PLUG IN THE PHONE LINE – This message will be displayed if the initialization fails because the AT&T VoiceMail Manager 200 cannot detect a phone line connected to it. Check your connections and make sure the line is free.

☎SWAP PHONE AND LINE – This message will be displayed if the initialization fails because the line from the wall jack is connected to the wrong ports on the AT&T VoiceMail Manager 200. Disconnect the power cord and make sure the lines are connected to the proper ports. Reconnect the power to restart the initialization.

☎NO DIAL TONE – This message will be displayed if the initialization fails because the AT&T VoiceMail Manager 200 cannot detect a dial tone. Check your connections and make sure the telephone line is free.

3