AT&T 7406 manual Speaker

Speaker

Note: Your voice terminal is set for either the Speaker (listen-only) or the Speakerphone (listen and talk) function. Check with your System Manager to see which of these two features you can use.

You can use the Reset Speakerphone feature only if your voice terminal is set for Speakerphone (listen and talk).

Use the following procedures if your voice terminal is set for the Speaker (listen- only) feature.

To place a call without lifting the handset, or to use speaker with any listening-only feature activity (such as, monitoring a call on which you have been put on hold or for group listening)

Note: In order for the other party to hear you, you must speak through the handset.

1Press [ Speaker Reset Spkr ]

●Green light next to [ Speaker Reset Spkr ] goes on; red light next to [ Mute ] goes on

2Place call or access selected feature

3Adjust speaker volume if necessary

●To raise the volume, press the right half of the Speaker Volume control button labeled [ ∧ ] ;

to lower the volume, press the left half of the Speaker Volume control button labeled [ ∨ ]

●If you have a display, it shows [ SPEAKER L > > > > H ]

(There are 8 possible volume settings. On the display, 1 arrow is the lowest setting, and 8 arrows is the highest setting)

To mute the microphone associated with the handset so the other party cannot hear you

1Press [ Mute ]

●Red light goes on and other party cannot hear you

2Press [ Mute ] again to resume talking to other party through handset

●Red light goes off and other party can hear you again

To activate the speaker 1 Press [ Speaker Reset Spkr ]

while using the handset

●	Green light next to [ Speaker ] and the red light
	next to [ Mute ] go on steadily
●	The speaker is active, and the handset is turned
	off

25