AT&T E2912 Low Battery, Troubleshooting, base but the CHARGE light is not on, refer to The CHARGE

Appendix

Troubleshooting

I cannot dial out. • First, try all the above suggestions.

•Make sure there is a dial tone before dialing. It is normal if the cordless handset takes a second or two to synchronize with the telephone before producing a dial tone. Wait an extra second before dialing.

•Check that all the telephones connected to the same telephone line are hung up.

•Makes sure the telephone is set to the correct dial mode (pulse dial or tone dial) for the service in your area. Refer to the Handset settings section of this user’s manual (page 18) to set the dial mode.

•If the other telephones in your home are having the same problem, the problem is in the wiring or local service. Contact your local telephone company (charges may apply).

•Eliminate any background noise. Noise from a television, radio, or other appliances may cause the telephone to not dial out properly. If you cannot eliminate the background noise, first try muting the cordless handset before dialing, or dialing from another room in your home with less back- ground noise.

LOW BATTERY		•	Place the handset in the base or charger for recharging.
is displayed on		•	Remove and re-install the battery and use it normally until
screen.
			fully discharged, then recharge the handset on the tele-
			phone base or charger for 16 hours.
		•	If the above measures do not correct the problem, the bat-
			tery may need to be replaced.
The battery does		•	Make sure the handset is placed in the telephone base or
not charge in the			charger correctly. The CHARGE light on the telephone base
handset	or the		or charger should be on.
handset	battery	•	If the cordless handset is in the charger or in the telephone
does not accept			base but the CHARGE light is not on, refer to The CHARGE

charge. light is off in this section (page 49).

48