AT&T E2912 user manual Belt clip & optional headset, Install belt clip as shown below if desired

Getting started

Belt clip & optional headset

Install belt clip as shown below if desired.

Snap belt clip into the notches on both sides of handset.

To release belt clip from handset, lift one side of the belt clip out of the notch.

For hands-free telephone conversations, use any industry standard 2.5 mm headset (purchased separately). For best results, use an AT&T 2.5 mm headset. To order an AT&T 2.5 mm headset, visit our website at www.telephones.att.com or call 1 (800) 222-3111. In Canada dial 1 (866) 288-4268.

Plug 2.5 mm headset into the jack on the side of hand- set (beneath small rubber cap).

NOTE: If the sound quality of the headset is not good, try unplugging it, and firmly plug- ging it in again.

TONE

MUTE REDIAL

DELETE PAUSE

10