AT&T EL42308, EL42208, EL42258 user manual Telephone base installation, Charger installation

Getting started

Telephone base & charger installation

If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL) through your telephone lines, you must install a DSL filter between the telephone base and the telephone wall jack. The filter will prevent noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters.

Install the telephone base and charger as shown below.

Telephone base installation

1.Plug the small

end of the power adapter into the power jack on the underside of the telephone base.

5.Plug the large end of

the power adapter into an electrical outlet not connected to a wall switch.

Charger installation

2. Plug one end of the telephone line cord into the telephone jack on the underside of the telephone base.

3. Route cords through slots.

DSL filter

(available from your DSL Internet provider)

4. Plug the other

	end of the
Telephone line cord	telephone line
	cord into a
	telephone jack.

Plug the power adapter into an electrical outlet not connected to a wall switch.

NOTES:

1.Use only the supplied rechargeable battery, replacement battery (part number

89-1332-00-00) or equivalent. To order a replacement battery, visit our website at

www.telephones.att.com or call 1 (800) 222-3111.In Canada, dial 1 (866) 288-4268.

2.This power adapter is intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under- the-table or cabinet outlet.