AT&T SL82308 This Troubleshooting guide, To the Battery installation and charging section of this

Appendix

Troubleshooting

	•	Reset the telephone base. Unplug the unit’s electrical
		power. Wait for 15 seconds then plug it back in. Allow
		up to one minute for the cordless handset and tele-
		phone base to reset.
	• Other electronic products can cause interference
		with your cordless phone. Try installing your phone
		as far away from these types of electronic devices
		as possible: television sets, VCRs, or other cordless
		telephones.
The batteries	•	If the cordless handset is in its base and the charge light
will not hold a		does not come on, refer to The charge light is off in
charge		this Troubleshooting guide.
	•	Charge the battery in the cordless handset for at least
		16 hours. For optimum daily performance, return the
		cordless handset to its base when not in use.
	•	You may need to purchase a new battery, please refer
		to the Battery installation and charging section of this
		user’s manual.
	•	Your phone might be malfunctioning. Please refer to the
		Limited warranty section of this user’s manual for fur-
		ther instruction.
I get noise,	•	If you subscribe to DSL service and if you hear noise
static, or weak		during conversations and/or your caller ID features are
signal even		not functioning properly, install a DSL filter to the tel-
when I’m near		ephone line between the telephone base and the tel-
the telephone		ephone line jack. Contact your DSL provider to obtain a
base		DSL filter.
	•	You may be able to improve the performance of your
		cordless phone by installing your new telephone base
		as far as possible from any other existing cordless tele-
		phone system that may already be installed.

• Other electronic products can cause interference to your cordless phone. Try installing your phone as far away from the following electronic devic- es as possible: television sets, VCRs, or other cordless telephones.

46