Appendix
Troubleshooting
Common cure | If the unit does not seem to be responding normally, try | |
for electronic | putting the cordless handset in its base. If it does not seem to | |
equipment | respond, do the following (in the order listed): | |
| • Disconnect the power to the telephone base. | |
| • | Disconnect the cordless handset battery, and spare battery, |
|
| if applicable. |
| • Wait a few minutes. | |
| • Connect power to the telephone base. | |
| • | |
|
| into the telephone base. |
| • | Wait for the cordless handset to |
|
| with the telephone base. Allow up to one minute for this to |
|
| take place. |
|
|
|
Incomplete | • | If a caller leaves a very long message, part of it may be |
messages |
| lost when the system disconnects the call after four min- |
|
| utes. |
| • | If the caller pauses for more than seven seconds, the |
|
| system stops recording and disconnects the call. |
| • | If the system’s memory becomes full during a message, |
|
| the system stops recording and disconnects the call. |
| • | If the caller's voice is very soft, the system may stop |
|
| recording and disconnects the call. |
|
|
|
Difficulty hear- | • | Press VOLUME to increase speaker volume. |
ing messages |
|
|
System does not answer after correct number of rings
•Make sure that the answering system is on (see page 39).
•If toll saver is activated, the number of rings changes to two when you have new messages stored (see page 35).
•If the memory is full or the system is off, the system will answer after 10 rings.
50
