Getting started
Battery installation & charging
Install the battery as shown below. After installing the battery, you can make and receive short calls, but replace the handset in the telephone base or charger when not in use. For optimal performance, charge the handset battery for at least 16 hours before use. When fully charged, the handset battery provides approximately five hours of talk time or three days of standby time.
If the battery is depleted, it may take approximately four minutes to charge the handset before it can resume screen display. The screen will continue to display LOW BATTERY until the battery has charged for approximately one hour.
UP |
|
|
|
SIDEUP | BT28433 |
| BURNNOTOR ORBURN |
THISSIDE Battery PackTHIS | 2.BT184334V 500mAh/ | ||
BT18433Battery Pack/ | 2.4V 500mAh WARNING: DO WARNING: DO PUNCTUREUREBATTERIESBATTERIES MADE INCHINA |
Step 1 | Step 2 |
Press the depression | Plug the battery securely |
and slide the battery | into the connector inside |
compartment cover | the handset battery |
downwards. | compartment, matching |
(if necessary) | the |
| Insert the supplied battery |
| with the label THIS SIDE |
| UP facing up as indicated. |
Step 4
Charge the handset by placing it face up in the telephone base or charger. The CHARGE light will be on when charging.
Step 3
Align the cover flat against the battery compartment cover, then slide it upwards until it clicks into place.
IMPORTANT INFORMATION
Use only the supplied rechargeable battery or replacement battery (model BT8001). To
order, visit our website at www.telephones.att.com or call 1 (800) 222- 3111. In Canada, dial 1 (866)
