Answering system
NOTES:
1.If a valid remote access code is not entered, the call will be ended automatically.
2.If you pause for more than four seconds during remote access, you will hear a help menu listing all features and commands. If there is no command for another 20 seconds, the call will end automatically.
3.If you want to delete all the old messages remotely, press 3 twice in remote standby mode.
4.If the memory is full, after 10 rings the answering system will answer and announce "Memory is full. Enter the remote access code." Enter your remote access code to access the messages and announcements.
Remote access
You can access your answering system remotely by dialing your home telephone number from any
To remotely access your answering system:
1.Dial your telephone number from any touch- tone telephone.
2.When the system answers, enter the two digit remote access code (19 is the default code, see page 48 to change it).
•If you have new messages, the system will automatically announce the number of new messages and then begin to play them.
3.You can also enter the following remote commands.
Remote commands
1Press to listen to all messages.
2Press to hear only new messages.
3Press to delete the current message (during playback).
3 3 Press twice to delete all old messages.
4Press to repeat the current message (during playback).
4 4 Press twice to listen the previous message.
5Press to stop any operation (including recording).
*5 Press to listen to a list of remote commands.
6Press to skip to the next message (during playback).
*7 Press to record a new announcement.
0Press to turn the answering system on or off.
8Press to end remote access (the call will be terminated).
4.Hang up to end the call and save all undeleted messages.
Cut out the remote access wallet card at the back of this user’s manual for quick reference.
53
