AT&T TL7612 quick start Headset base and handset lifter installation

Headset base and handset lifter installation

Option 1: Connect the handset lifter to a corded phone

1.Unplug the curly handset cord from the telephone and plug

it into the CURLY CORD jack (light blue dot) on the headset base.

2.Plug one end of the telephone line cord (provided with the headset base) into the base handset jack on the telephone where the curly handset cord was originally plugged in.

3.Plug the other end of the line cord into the BASE JACK (orange dot) on the headset base.

4.Plug the lifter control cable into the jack of the base adapter.

5.Plug the other end of the base adapter into the LIFTER jack (blue dot) on the headset base.

Adjust the corded handset audio (see page 17) before you install the handset lifter to your telephone. See page 18 to attach the handset lifter. Make sure the headset base mode is set to LIFTER MODE.

Plug the small end of the headset base power adapter to the POWER jack (green dot) on the headset base.

Plug the large end of the headset base power adapter into a power outlet not controlled by a wall switch.

3

51

Telephone
wall jack	4

A DSL filter (not included) is required if you have DSL

high-speed Internet service.

Telephone line cord

2

16