Headset base installation
Option 2: Connect the headset to a telephone wall jack
In order to make calls using this installation option, you need a telephone plugged into the same telephone line or a dial pad (TL7601 purchased separately). Make sure the headset base mode is set to NO LIFTER MODE.
• Plug the small end of | • Plug one end of |
the headset base power | the telephone line |
adapter into the POWER | cord into the |
jack (green dot) at the | TEL WALL JACK |
back of the headset base. | (red dot) at the |
| back of the |
| headset base. |
•Plug the headset base power adapter into an electrical outlet not controlled by a wall switch.
Telephone line cord
•Plug the other end of the telephone line cord
into a telephone jack.
A DSL filter (not included) is required if you have DSL
NOTE: For more information about the accessory dial pad (model TL7601),
visit our website at www.telephones.att.com.
24