|
| Chapter 1. Introduction | |
|
|
|
|
|
|
|
|
|
|
|
|
No. | Component | Description | |
|
|
|
|
1 | Handle | Pull to slide the KVM module out; push to slide the module in | |
|
| (see item 2 in this table). | |
|
|
|
|
2 | Slide Release | In order to slide the console out, you must first release it by | |
|
| sliding these tabs to the inside. See page 13 for details on | |
|
| sliding the console in and out. | |
|
|
|
|
3 | LCD Display | After sliding the KVM module out, flip up the cover to access | |
|
| the LCD monitor. | |
|
|
|
|
4 | LCD Controls | The LCD On/Off switch is located here, as well as buttons to | |
|
| control the position and picture settings of the LCD display. | |
|
| ||
|
|
|
|
5 | Port Switches | Press a switch to bring the KVM focus to the computer | |
|
| attached to its corresponding port. See page 19 for details. | |
|
|
|
|
6 | Port LEDs | Two Port LEDs are built into the Port Switches. The one on | |
|
| the left is the On Line LED; the one on the right is the | |
|
| Selected Port LED: | |
|
| An On Line LED lights ORANGE to indicate that the | |
|
| computer attached to its corresponding port is up and | |
|
| running. | |
|
| A Selected LED lights GREEN to indicate that the | |
|
| computer attached to its corresponding port has the KVM | |
|
| focus. The LED is steady under normal conditions, but | |
|
| flashes when its port is accessed under Auto Scan Mode | |
|
| ||
|
|
|
|
7 | Keyboard |
|
|
|
|
|
|
8 | Touchpad |
|
|
|
|
|
|
9 | Power LED | Lights DARK GREEN to indicate that the unit is receiving | |
|
| power. | |
|
|
|
|
10 | Rack Mounting | The rack mounting brackets located at each corner of the unit | |
| Brackets | secure the chassis to a system rack. | |
|
|
|
|
11 | Lock LEDs | The Num Lock, Caps Lock, Scroll Lock LEDs are located | |
|
| here. | |
|
|
|
|
12 | Reset Switch | Located to the right of the Lock LEDs. Press this recessed | |
|
| switch in with a small object to perform a system reset. | |
|
|
|
|
13 | Firmware | Firmware Upgrade Port: The Firmware Upgrade Cable | |
| Upgrade | that transfers the firmware upgrade data from the | |
| Section | administrator's computer to the CL1008 / CL1016 plugs | |
|
| into this | |
|
| Firmware Upgrade Switch: During normal operation this | |
|
| switch should be in the NORMAL position. (See page 41 | |
|
| for firmware upgrading details.) | |
|
|
|
|
5