Chapter 5. Hotkey Operation
Hotkey Beeper Control
The beeper can be hotkey toggled on and off (see ACTIVATE BEEPER, page 29). To toggle the beeper, key in the following hotkey combination:
1.Invoke Hotkey mode (see page 35).
2.Press [B]
After you press B, the beeper toggles on or off. The command line displays Beeper On or Beeper Off for one second; then the message disappears and you automatically exit Hotkey mode.
Hotkey Summary Table
[Num Lock] + | [Port ID] [Enter] | Switches the KVM focus to the computer that |
|
| corresponds to that port ID |
|
|
|
| [T] [n] [Enter] | Sets the Auto Scan interval to n seconds – where |
|
| n is a number from |
|
|
|
| [A] | Invokes Auto Scan mode. |
|
| When Auto Scan mode is in effect, [P] or left |
|
| click pauses auto scanning. |
|
| When auto scanning is paused, pressing P or |
|
| left clicking again resumes auto scanning. |
|
| Note: Pressing almost any of the typewriter keys |
|
| (letters, numbers, Enter, Esc, Spacebar, etc.), will |
|
| resume scanning. |
|
|
|
| [←] | Skips from the current port to the first accessible |
|
| port previous to it. (See SCAN/SKIP MODE, |
|
| page 27, for information regarding accessible |
|
| ports.) |
|
|
|
| [→] | Skips from the current port to the next accessible |
|
| port. |
|
|
|
| [↑] | Skips from the current port to the last accessible |
|
| port of the previous station. If you are at a port on |
|
| the first station you cycle backward to the last |
|
| accessible port on the last station. |
|
|
|
| [↓] | Skips from the current port to the first accessible |
|
| port of the next station. If you are at a port on the |
|
| last station you cycle forward to the first accessible |
|
| port on the first station. |
|
|
|
| [B] | Toggles the beeper on or off. |
|
|
|
39