CL1008 / CL1016 User Manual
(Continued from previous page.)
Setting | Function |
|
|
SET QUICK | This function lets the administrator select which ports to include as |
VIEW PORTS | quick view ports. |
| To select/deselect a port as a quick view port, use the navigation |
| keys to move the highlight bar to it, then press the [Spacebar]. |
| When a port has been selected as a quick view port, an |
| arrowhead displays in the QV column of the list on the main |
| screen. When a port is deselected, the arrowhead disappears. |
| If one of the quick view options is chosen for the list view (see F2 |
| LIST, page 25), only a port that has been selected here will |
| display on the list. |
| If one of the quick view options is chosen for auto scanning (see |
| SCAN/SKIP MODE, page 27), only a port that has been selected |
| here will be auto scanned. |
| The default is for no ports to be selected. |
|
|
SET | This function allows the administrator to define user access to the |
ACCESSIBLE | computers on the installation on a |
PORTS | For each user, select the target port; then press the [Spacebar] to |
| |
| cycle through the choices: F (Full access), V (View only), or blank. |
| Repeat until all access rights have been set, then press [Enter]. |
| The default is F for all users on all ports. |
| Note: A blank setting means that no access rights are granted. The |
| port will not show up on the user's list on the main screen. |
|
|
RESET STATION | If you change the position of one of the stations in the |
IDS | the OSD settings will no longer correspond to the new situation. |
| This function directs the OSD to rescan the station positions of the |
| entire installation and updates the OSD so that the OSD station |
| information corresponds to the new physical layout. |
| Note: Only the station numbers get updated. Except for the port |
| names, all administrator settings (such as set accessible ports, set |
| quick view ports, etc.), for all of the computers affected by the |
| change, have to be manually redone. |
|
|
FIRMWARE | In order to upgrade the CL1008 / CL1016's firmware (see |
UPGRADE | Chapter 6), you must first enable Firmware Upgrade Mode with this |
| setting. |
| When you bring up this menu, the current firmware version levels |
| display. Select Y to enable Firmware Upgrade mode, or N to leave |
| this menu without enabling it. |
|
|
30