
CM1164
Port ID Display
The Port ID Display command allows you to change the port ID numbers displayed for each port. Use the Formula - to set Parameters - to create a Command.
Formulas:
Command + Control + [Enter]
Set Port ID and Display Duration:
Command + Control + Number + [Enter]
Parameters:
Command | Description |
|
|
portid | Port ID Display Command |
|
|
|
|
Control | Description |
|
|
pxxx | Change port, x= 1~4 (Port Number) |
| xx= 1~99 (New Port Number) |
| Example: p478 |
|
|
default | Reset all port ID’s to the factory default |
|
|
txx | Set ID display duration, xx= 1~99 seconds |
| Example: t55 |
|
|
|
|
Enter | Description |
|
|
Enter | Enter and send out command |
|
|
Port ID Display Commands
Some available formulas for Port ID Display commands are as follows:
1. Command + Control + [Enter]
For example, to set all port ID’s to the factory default, type the following: portid default [Enter]
2. Command + Control + Number + [Enter]
For example, to change port 4’s ID number to 37, type the following: portid p437 [Enter]
(Continues on next page.)
20