ATEN Technology CM1164 Verification, RS-232Commands

CM1164 RS-232 Control Tool

RS-232 Commands

After you login via HyperTerminal (see Console Login - HyperTerminal, page 4), you can use the instructions below to send RS-232 commands to control the CM1164 from a remote system. For more detailed instructions and information about each of the RS-232 commands listed below, please refer to the original CM1164 user manual.

Verification

After entering a command, a verification message appears, as shown below, at the end of the command line, as follows:

Response Message	Description
command OK	Command or parameter is correct.
command incorrect	Command or parameter is incorrect.
NOT Login	Command sent without RS232 login.
login OK	Password correct and login successful.
login FAIL	Incorrect password.
SETTING OK	Some commands support the “save” parameter, so when you
	input “save” the system will check all current input commands
	and parameters, and a feedback message of “SETTING OK”
	will return if all commands and parameters are correct.
	Otherwise the system will return a “SETTING FAIL” message.
SETTING FAIL	Some commands support the “save” parameter, so when you
	input “save” the system will check all current input commands
	and parameters, and a feedback message of “SETTING FAIL”
	will return if a command or parameter is incorrect.

5