1. Introduction

 

 

 

 

 

 

 

 

 

No.

Component

Description

 

 

 

1

Port Selection

Š Press a switch to access the computer attached to its

 

Switches

corresponding port.

 

 

Š Pressing buttons 1 and 2 simultaneously for 2 seconds

 

 

performs a keyboard and mouse reset.

 

 

Š For the CS-1754, pressing buttons 3 and 4

 

 

simultaneously for 2 seconds starts Auto Scan Mode; for

 

 

the CS-1758, pressing buttons 7 and 8 simultaneously

 

 

for 2 seconds starts Auto Scan Mode. See Auto Scan

 

 

Mode, page 36, for details.

 

 

 

2

Port LEDs

The Port LEDs are built into the Port Selection Switches.

 

 

The upper ones are the On Line LEDs; the lower ones are

 

 

the Selected Port LEDs:

 

 

Š The On Line LEDs light ORANGE to indicate that the

 

 

computer attached to its corresponding port is up and

 

 

running. If the LED is flashing, it indicates that the Port is

 

 

being used for cascading to another Master View switch

 

 

(see Two Stage Installation, page 14).

 

 

Š The Selected LEDs light GREEN to indicate that the

 

 

computer attached to its corresponding port is the one

 

 

that has the KVM focus. The LED is steady under

 

 

normal conditions, but flashes when its port is accessed

 

 

under Auto Scan Mode (see Auto Scan Mode, page 36,

 

 

and F7 SCAN, page 32).

 

 

 

3

Reset Switch

Š Pressing this switch in for less than three seconds

 

 

performs a warm reset.

 

 

Š Pressing this switch in for more than three seconds

 

 

performs a cold reset.

 

 

Note: The switch is recessed and must be pushed with a

 

 

thin object - such as the end of a paper clip, or a ball point

 

 

pen.

 

 

 

4

Power LED

The Power LED lights to indicate that the CS-1758is

 

 

powered up and ready to operate.

 

 

 

5