Chapter 1. Introduction
(Continued from previous page.)
No. | Item | Description |
|
|
|
3 | Station ID | The PN9108's Station ID usually displays here. If this is a Single |
| LED | Station installation (see page 10), or the First Station on a Daisy |
|
| Chained installation (see page 12), the PN9108 has a Station ID |
|
| of 01. |
|
| The current status (in amps) displays here (instead of the |
|
| Station ID) when the Current Display Switch is toggled ON (see |
|
| item 7, below). |
|
|
|
4 | 10/100 | The LED lights ORANGE to indicate 10 Mbps data transmission |
| Mbps Data | speed. |
| LED | The LED lights GREEN to indicate 100 Mbps data transmission |
|
| |
|
| speed. |
|
|
|
5 | Power LED | Lights when the PN9108 is powered up and ready to operate. |
|
|
|
6 | Power | Each button (A to H), controls the power status of its |
| Control | corresponding AC output port as follows: |
| Buttons | Pressing the button for less than 3 seconds toggles the port |
|
| |
|
| between Remote Access enabled and Remote Access disabled |
|
| (Local Mode). If Remote Access is disabled, the switch does not |
|
| allow the port to be managed from a remote connection. |
|
| Under Local Mode, pressing and holding the button in for more |
|
| than 3 seconds switches the power to its corresponding port On |
|
| or Off. |
|
|
|
7 | Current | Toggles between showing the Station ID and current status (in |
| Display | amps) on the Station ID LED. |
| Switch |
|
|
|
|
8 | Reset | Pressing and holding this switch in for more that three seconds |
| Switch | resets the PN9108 to its factory default settings. This switch is |
|
| recessed and must be pushed with a thin object, such as the end |
|
| of a paper clip, or a ballpoint pen. |
|
|
|
9 | Link LED | Lights GREEN to indicate that a connection via the PN9108's RJ- |
|
| 45 Ethernet port has been established. Flashes to indicate that |
|
| data is being transmitted. |
|
|
|
5