For Windows NT4.0 | Atlantis Land A02-RAV211 instruction

VoIP ROUTER ADSL

For Windows NT4.0

1.Go to Start / Settings / Control Panel. In the Control Panel, double-click on Network and choose the Protocols tab.

2.Select TCP/IP Protocol and click Properties.

3.Select the Obtain an IP address from a DHCP server radio button and click “OK”.

10

Image 16

Atlantis Land A02-RAV211 manual For Windows NT4.0

Contents

VoIP Router Adsl Page Copyright CE Mark WarningImportant Note FCC Warning Table of Contents Chapter Chapter Page Introduction An Overview of the VoIP Router Adsl Package Contents VoIP Router Adsl FeaturesPage VoIP Router Adsl Application Front LEDs Rear Ports Cabling Before Configuration Connecting the VoIP Router Adsl Configuring PC in Windows For Windows 95/98/ME VoIP Router Adsl For Windows NT4.0 For Windows Click OK to finish the configuration For Windows XP VoIP Router Adsl Factory Default Settings Username and Password Configuring with the Web Browser Information from the ISP Status Quick Start Status Adsl Status Adsl Status WAN Status Adsl Status ATM Status Status LAN Status LAN Status TCP Status Status- PPP Status Status- Learned MAC Table Routing Table System Log Quick Start Security LogsAdsl Quick Start VoIP Quick Start ConfigurationVoIP System Firewall Virtual Server Advanced 3.1 WAN VoIP Router Adsl Static IP Settings Service Category Select UBR or CBR Dhcp ClientMAC Spoofing 3.2 LAN Device IP Address Dhcp Server VoIP VoIP Router Adsl AuthorizationUserID Same as UserID Phone Book CallWaiting Enable/Disable the call waiting feature Call FeatureCallForwarding Advanced Telephony Settings CallReturn Enable/Disable the call return feature Configure Caller ID info Echo Cancellation Tail Length Setting the Tail Length Ring & Tone Configuration Timeouts System Password Time Zone Factory Setting UpgradeRestart Firewall Packet Filtering VoIP Router Adsl Bridge Filtering Intrusion Detection Block WAN Request Virtual Server Advanced Adsl 3.7.2 DNS Dynamic DNS 3.7.4 NAT VoIP Router Adsl RIP Default is Disabled Border Gateway Default is Enabled 3.7.5 RIP Static Route Misc Configuration Dhcp Relay Default at Dhcp Server Dhcp Target IP Default is Diagnostic Test Igmp Proxy Default at DisabledTesting Ethernet LAN connection Testing Adsl Synchronization Test ATM OAM Segment Loop Back Test ATM OAM End-to-End Loop BackTest Ethernet connect to ATM Test IP connect to PPP Save Config Test Internet connection Problems with the LAN Interface Problems with the WAN InterfaceProblem Corrective Action Technical Features Appendix B Support