Click OK to finish the configuration | Atlantis Land A02-RAV211

VoIP ROUTER ADSL

4.Select Internet Protocol (TCP/IP) and click Properties.

5.Select the Obtain an IP address automatically and the Obtain DNS server address automatically radio buttons.

6.Click “OK” to finish the configuration.

12

Image 18

Atlantis Land A02-RAV211 manual Click OK to finish the configuration

Contents

VoIP Router Adsl Page Important Note CopyrightCE Mark Warning FCC Warning Table of Contents Chapter Chapter Page Introduction An Overview of the VoIP Router Adsl Package Contents VoIP Router Adsl FeaturesPage VoIP Router Adsl Application Front LEDs Rear Ports Cabling Before Configuration Connecting the VoIP Router Adsl Configuring PC in Windows For Windows 95/98/ME VoIP Router Adsl For Windows NT4.0 For Windows Click OK to finish the configuration For Windows XP VoIP Router Adsl Factory Default Settings Username and Password Configuring with the Web Browser Information from the ISP Status Quick Start Status Adsl Status Adsl Status WAN Status Adsl Status ATM Status Status LAN Status LAN Status TCP Status Status- PPP Status Status- Learned MAC Table Routing Table System Log Security Logs Quick StartAdsl Quick Start Configuration VoIP Quick StartVoIP System Firewall Virtual Server Advanced 3.1 WAN VoIP Router Adsl Service Category Select UBR or CBR Dhcp Client Static IP SettingsMAC Spoofing 3.2 LAN Device IP Address Dhcp Server VoIP VoIP Router Adsl AuthorizationUserID Same as UserID Phone Book Call Feature CallWaiting Enable/Disable the call waiting featureCallForwarding Advanced Telephony Settings CallReturn Enable/Disable the call return feature Configure Caller ID info Echo Cancellation Tail Length Setting the Tail Length Ring & Tone Configuration Timeouts System Password Time Zone Upgrade Factory SettingRestart Firewall Packet Filtering VoIP Router Adsl Bridge Filtering Intrusion Detection Block WAN Request Virtual Server Advanced Adsl 3.7.2 DNS Dynamic DNS 3.7.4 NAT VoIP Router Adsl RIP Default is Disabled Border Gateway Default is Enabled 3.7.5 RIP Static Route Misc Configuration Dhcp Relay Default at Dhcp Server Dhcp Target IP Default is Testing Ethernet LAN connection Diagnostic TestIgmp Proxy Default at Disabled Testing Adsl Synchronization Test Ethernet connect to ATM Test ATM OAM Segment Loop BackTest ATM OAM End-to-End Loop Back Test IP connect to PPP Save Config Test Internet connection Problems with the WAN Interface Problems with the LAN InterfaceProblem Corrective Action Technical Features Appendix B Support