Ten Tips to Obtain the Best Results

1.Use only fresh alkaline batteries. Do not use “general purpose” (carbon-zinc) batteries.

2.Position the receiver so that it has the fewest possible obstructions between it and the normal location of the transmitter. Line-of-sight is best.

3.The transmitter and the receiver must be set to the same frequency. Set or change transmitter frequency only when its power is turned off.

4.The transmitter and the receiver should be as close together as conveniently possible, but no less than six feet (2 m.).

5.Yellow LED indicates the channel is set to service position (0 or 9); please select a valid operating channel (1-8).

6.The receiver antennas should be kept away from any metal.

7.A receiver cannot receive signals from two transmitters at the same time.

8.If the AF Level control of the receiver is set too high, it may over-drive the input of the mixer or clip the output of the receiver, causing distortion. Conversely, if the receiver output is set too low, the overall signal-to-noise ratio of the system may be reduced. Adjust the output level of the receiver so the highest sound pressure level going into the microphone (or the loudest instrument playing level) causes no input overload in the mixer, and yet permits the mixer level controls to operate in their “normal” range (not set too high or too low). This provides the optimum signal-to-noise for the entire system.

9.In the UniPak transmitter, the “Mic” or “Inst” input control not in use should be set to minimum.

10.Turn the transmitter off when not in use. Remove the battery if the transmitter is not to be used for a period of time. Unplug the receiver from the AC outlet when the system is not in use.

For future reference, please record your system information here (the serial numbers appear inside the battery compartment of each transmitter, and on the bottom of each receiver):

Receiver

ATW-R700

S/N

UniPak™ Body-Pack

ATW-T701

S/N

Transmitter

 

 

Handheld Dynamic

ATW-T702

S/N

Microphone Transmitter

Page 8
Image 8
Audio-Technica ATW-701G, ATW-702, ATW-701P, ATW-701H manual Ten Tips to Obtain the Best Results